Editor's Comment: I Had to Open My Mouth - Tire Review Magazine

Editor’s Comment: I Had to Open My Mouth

I had to say it, didn’t I? I should have known better than to put proverbial pen to paper and write “unless there is an unlikely 11th hour stay of execution at the European parliament.”

I should have known better because no sooner had these words gone to print than exactly this happened. I am, of course, referring to the wonderful S-mark legislation (also known as regulation 2001/43), which has become the subject of so much coverage in Tyres & Accessories recently. Apparently, tyres won’t necessarily need an S-mark to comply with regulation 2001/43 and, er, be S-marked.

However, it doesn’t end there. The latest from the Department for Transport is that there has been a “delay in putting into place the statutory instrument which is required for the new S-marking regulations to become law.” In short, there won’t be any means of enforcing the new law in the U.K. until March 2010. This fact doesn’t affect the other European markets, which will all have to comply by the original Oct. 1 deadline.

While this loophole provides further time to clear stocks of non-S-marked tyres, the new deadline is seen as the last chance saloon and the “Vehicle Certification Agency and Trading Standards will be vigorously enforcing the law which has penalties of up to £5,000 fine on each tyre sold” from March 2010. Therefore, the NTDA is warning members not to buy any non s-marked stock, which could come into the U.K. from European countries (such as Germany, France and Holland) that have to comply with the Oct. 1 deadline.

In addition, as you have probably heard by now, the European Commission has modified its interpretation of regulation 2001/43 so dealers with compliant but non-S-marked stock will be able to sell them under the following circumstances (see below). While the new system is clearly not a self-certification system, this decision (made on July 6) does offer much-needed clarification and flexibility to the market. However, this is also being challenged through the commission’s “commentology” process, challenges T&A understands the ruling is unlikely to survive.

Nevertheless, here’s the situation as it currently stands. According to the European Tyre and Rubber Manufacturers Association (ETRMA), the following stipulations constitute the commission’s final decision and no physical S-marking will be required if: Each type of tyre is submitted to a test to show compliance with the noise requirements set out in Directive 2001/43/EC; a test report is produced (by the tyre manufacturers, in the event they are accredited as technical services, or by any other accredited technical service) and validated by a type-approval authority (not necessarily the same who delivered the original type-approval); and if each tyre sold is accompanied by a certificate summarising the information contained in the test report.

Crucially, this additional legal leeway only applies to tyres produced by week 40 of 2009. And, in order to prevent possible abuses, member states committed on July 6 to send a letter to the national retailers’ associations urging them not to buy any tyre which would not bear the S-marking according to Directive 2001/43/EC.

However, at this stage it is not at all clear if the above compromise will be ratified come September. As for me, this month I am keeping my mouth closed. (Chris Anthony – Tyres & Accessories/Staffordshire, U.K.)

You May Also Like

Yokohama Rubber donates to Eastern Taiwan earthquake relief

Through its Yokohama Magokoro Fund, Yokohama Rubber will donate a combined ¥1 million (approx. $6,380).

donate-stock

Yokohama Rubber shared its deepest condolences and sympathies to the families who have lost loved ones and to all those who have been affected by the earthquake in Eastern Taiwan. In response, Yokohama Rubber and its employee-backed Yokohama Magokoro Fund said it will donate a combined ¥1 million (approx. $6,380) through the Japanese Red Cross Society to support relief efforts in the region.

Continental acquires mold specialist EMT for commercial and specialty tires

With the acquisition of EMT, Continental said it can independently produce tire molds for all applications if required.

continental_pp_tiremold
TBC Corp. employee children enjoy ‘Take Your Child to Work Day’

The kids had a jam-packed day learning about tires, and even ate lunch with the company’s new CEO, Don Byrd.

TBC-Bring-Kids-to-Work-Day-CEO-1400
Mitas, Trelleborg to increase prices globally

The companies said this decision is a response to significant inflation.

BKT celebrates International Day of Sport for Development and Peace

BKT said it has made an effort to show a commitment to supporting sports through multiple initiatives, partnerships and sponsorships.

BKT-sports-sponsorships

Other Posts

Bridgestone invests in Yoshi Mobility to expand into virtual inspection, EV charging

Yoshi is also commercializing its mobile EV charging platform to address EV fleet charging challenges.

Yoshi-Mobility-EV-charging
SRNA introduces new field engineer manager

Chariarse has extensive experience in his field, working as a commercial truck field engineer in the tire industry for the past 21 years.

SRNA-Eduardo-Chariarse
Bridgestone to debut Bandag Virtual World Tour at WasteExpo 2024

The Bandag Virtual Plant Tour is an internet browser-based experience that provides a step-by-step walkthrough of Bandag’s retreading process.

Bandag-virtual-tour-Bridgestone
Giti Tire Manufacturing awarded by Chester County Chamber of Commerce

Giti Tire said it has been a supporter of education, organized farmer’s markets and participated in community food drives.

Giti-Chamber-Award